Waveshare ESP32-S3-GEEK Example
This example shows how to use the espp::WsS3Geek hardware abstraction
component initialize the components on the Waveshare ESP32-S3-GEEK.
It initializes the display, and button subsystems.
How to use example
Hardware Required
This example is designed to run on the Waveshare ESP32-S3-GEEK dev board which has:
WiFi / BLE
uSD card
Color TFT LCD (ST7789P3, 240x135 1.14” IPS LCD)
Boot Button
Build and Flash
Build the project and flash it to the board, then run monitor tool to view serial output:
idf.py -p PORT flash monitor
(Replace PORT with the name of the serial port to use.)
(To exit the serial monitor, type Ctrl-].)
See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.
Example Output
[WsS3Geek Example/I][0.026]: Starting example!
[WsS3Geek/I][0.032]: Initializing LCD...
I (357) gpio: GPIO[8]| InputEn: 0| OutputEn: 1| OpenDrain: 0| Pullup: 0| Pulldown: 0| Intr:0
I (365) gpio: GPIO[9]| InputEn: 0| OutputEn: 1| OpenDrain: 0| Pullup: 0| Pulldown: 0| Intr:0
[WsS3Geek/I][0.453]: Initializing display with pixel buffer size: 12000 bytes
W (776) ledc: the binded timer can't keep alive in sleep
[WsS3Geek/I][0.458]: Initializing SD card
I (782) gpio: GPIO[34]| InputEn: 0| OutputEn: 1| OpenDrain: 0| Pullup: 0| Pulldown: 0| Intr:0
I (830) sdspi_transaction: cmd=52, R1 response: command not supported
I (872) sdspi_transaction: cmd=5, R1 response: command not supported
[WsS3Geek/I][0.576]: Filesystem mounted
Name: 00000
Type: SDHC
Speed: 20.00 MHz (limit: 20.00 MHz)
Size: 30543MB
CSD: ver=2, sector_size=512, capacity=62552064 read_bl_len=9
SSR: bus_width=1
[WsS3Geek Example/I][0.583]: Initializing the button
[WsS3Geek/I][0.589]: Initializing button
I (915) gpio: GPIO[0]| InputEn: 1| OutputEn: 0| OpenDrain: 0| Pullup: 1| Pulldown: 0| Intr:3