LP5817 Example
This example shows how to use the espp::Lp5817 component to control an RGB LED over I2C.
It is designed for ESP32-S3 but can be adapted by changing the I2C pins.
How to use example
Hardware Required
This example can run on and ESP microcontroller with I2C connected to an LP5817
RGB LED driver. You should run idf.py menuconfig to set the I2C pins to match
your hardware configuration.
Configuration
Run idf.py menuconfig to set the I2C pins to match your hardware
configuration, or select a predefined board configuration.
Build and Flash
idf.py -p PORT flash monitor
(Replace PORT with the name of the serial port to use.)
(To exit the serial monitor, type Ctrl-].)
See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.