MAX1704X Example
This example shows how to use the MAX1704X driver to control
How to use example
Hardware Required
This example requires a connection (via I2C) to a dev board which has a MAX1704X
battery gauge chip. The example was tested with a QtPy ESP32s3 dev board and a
MAX1704X breakout board from Adafruit, but can be configured (using
menuconfig) to run on any ESP board by configuring the I2C pins and selecting
CUSTOM hardware.
Build and Flash
Build the project and flash it to the board, then run monitor tool to view serial output:
idf.py -p PORT flash monitor
(Replace PORT with the name of the serial port to use.)
(To exit the serial monitor, type Ctrl-].)
See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.